Quick answer

Plan infantry, lancers and marksmen for each situation, then adjust ratios using battle reports.

Whiteout Survival

First decide whether the march is for gathering, wilderness targets, joining a rally or defense. Gathering emphasizes load and time; player combat needs a sufficient frontline; Bear Hunt uses more damage troops according to your alliance leader's instructions. The figures below are test starting points for recording battle reports, not optimal ratios for every state and hero.

Understanding the three troop types and ratios

Ratios are written as infantry/lancers/marksmen. Infantry absorb damage at the front, lancers stand in the middle and marksmen at the rear. Results also depend on troop tier and count, heroes' expedition skills, technology and opponent attributes. If your alliance commander specifies a ratio or first hero, follow the rally instructions rather than overriding them with a personal preset.

Situation First setup to try What to compare
Gathering Choose a resource node and heroes with gathering skills, then provide enough load; no fixed three-type ratio is required Amount gathered and travel and return time; keep troops for combat and reinforcements.
Solo wilderness targets Bring high-tier troops and expedition heroes capable of winning; use 40/30/30 as a comparison Wins and injured troops; if injuries remain high, improve tier or technology or choose a lower target.
Rally attack against players Test 50/20/30 once, unless your alliance leader specifies otherwise Opponent lineup, casualties and actual battle report; different generations may call for very different setups.
Alliance city defense/garrison Try 60/20/20 for a thicker frontline Garrison capacity, damage absorbed and enemy lineup; do not permanently assign all troops to one march on this basis.
Bear Trap Some alliances start at 10/10/80 or request more marksmen Check the leader's troop limit and damage for that event; do not carry this damage-focused ratio straight into player attacks or defense.

Sending marches to gather or fight wilderness targets

For gathering, check the resource type, remaining quantity and load first, then choose heroes with the appropriate gathering speed and troops. Sending far more load than necessary generally does not increase the node's size. Load can differ by troop type and tier: confirm the deployment screen shows enough actual load to carry the target amount, then plan other marches.

For wilderness targets, begin at a level you can beat consistently and read battle reports rather than power alone. Check the descriptions of heroes' expedition skills and troop bonuses. After improving training or combat technology, compare wounded troops and time against a target of the same level. If an event gives limited stamina, check rewards and alliance goals first.

Leading versus joining a rally

When leading, set the target, rally time, participant limit and three heroes, and tell allies which troops and heroes you want. When joining, check the time remaining, whether the rally is full and the commander's requirements. A long march can miss the rally; move closer or choose a shorter route first. Events differ in how they use joiners' hero skills, so an Arena lineup is not automatically the answer for every rally.

Adjust using two battle reports

Record target type, heroes, troop tiers, troop count and ratio. Change one factor at a time where possible, then compare. For example, start against same-level wilderness enemies at 40/30/30; if wounded troops are concentrated at the front, consider adding infantry or strengthening the frontline. For Bear Hunt, look at the alliance's total damage and do not attribute every change to the ratio. Reports with different event difficulty, hero gear or opponents cannot prove one ratio is universally stronger.

Sources

Revision history

— Recently updated